Doug Manninen
10-27-2009, 05:08 AM
1-EJ22T motor with #4 Cyl. no compression. Needs rebuild after turbo blew. (Long Block)
2-2.5L N.A. Piston rod bearing gone heads are in good shape and are currently bolted to motor listed below. (short Block)
3-EJ22T This motor's bottom end is good, I bought the 2.5 motor (Listed Above) for the heads with new rubber seals and bolted them on, but motor compression was to low, I did not realize I had to change out piston to a wiseco piston made for this application. It also has 2002 WRX intake on this motor.
I do not have time to build these motors, so I am not holding on to them, and need the garage space. My 22B motor will have to wait.
$200 for everything.
2-2.5L N.A. Piston rod bearing gone heads are in good shape and are currently bolted to motor listed below. (short Block)
3-EJ22T This motor's bottom end is good, I bought the 2.5 motor (Listed Above) for the heads with new rubber seals and bolted them on, but motor compression was to low, I did not realize I had to change out piston to a wiseco piston made for this application. It also has 2002 WRX intake on this motor.
I do not have time to build these motors, so I am not holding on to them, and need the garage space. My 22B motor will have to wait.
$200 for everything.