I just tried heel-toe downshifting, and realized my foot is too narrow to do it properly. I need a wider gas pedal or brake pedal. Any ideas? After-market one?
I just tried heel-toe downshifting, and realized my foot is too narrow to do it properly. I need a wider gas pedal or brake pedal. Any ideas? After-market one?
Social Dictator
Melanie
You can wear some of my wide shoes.
In the past, Fourstar heated my gas pedal with a torch and bent the gas pedal to where I needed it. However, Subaru might have changed the pedal shaft to plastic like other manufacturers.
I also like an adjusting rod added to the brake pedal to increase the brake pedal height, but maybe Subaru has done a better job with that on the 2015.
With the drive by wire setup, you can no longer bend the gas pedal arm. But you can buy yourself some fancy brake pedal / gas pedal covers.
This helps to widen the gas, brake and clutch pedals. Look at the pictures here: http://legacygt.com/forums/showthrea...nual-7639.html
http://www.subaru.com.au/sti-perform...dal-pad-set-mt
I've got those (the link for legacygt.com). It did help over stock pedals.
-----
formerly SubLeg05
#88
I modified the gas pedal mount on my 2011.
http://forums.nasioc.com/forums/show....php?t=2377058
For really wide pedals I end up doing a pivot on the ball of my foot and actually catch the throttle with my heel, rather than the side of my foot.
That's what I normally do Bryce, but the centre pillar/firewall (not quite sure what it's called) under the dash doesn't give you a lot of wiggle room, so when I move my foot to "ankle/side of foot"-toe downshift, the centre gets in the way and there's just no room, unless I actually lift my entire leg, which I'd really rather not do.
So it looks like pedal extension, or pedal modification for me.
Walter, the instructions on that link aren't really clear, maybe this weekend, when we have a free moment at the ADC, we can go over it a bit better?
Social Dictator
Melanie
Sure.
The plastic gas peddle is mounted to a metal plate with two bolts. The mod is to re-position the lower mounting bolt so the bottom of the gas peddle swings toward the brake.
Ok, that makes better sense than the pics!
Social Dictator
Melanie
Are you Heel Toeing or Toe edging???
I can't heel toe, but toe edge all my downshifts easily. the wider the shoe the easier it is...
Another suggestion on pedal covers is the Cusco Gas Pedal Extender. I have purchased it but not installed it yet, it was originally designed for the FRS/BRZ but if the 2015's pedal is the same as the previous generations this should work.
Martin Wong
2009 SSM STI